| Author | Message | |||||||||
| Chuck_a
Crappie Username: Chuck_a Post Number: 329 Registered: 2-2008  Rating: N/A |
I am at Fork for a couple of days and my boat isnt running right. I only have a few more days before I have to go back to New Jersey. The boat ran perfect the last time I had it out. Which was the JCO tourney in Aug or Sept I know letting it sit for months at a time is not good. Before I moth balled it, I used Stabil, filled it up with ethanol free gas, and cleaned the back well. I started it up this mornin and it sounded OK. When I went to get on plane I could only get about 3,000 RPMs. I do not remember when, but the water filters in the feul system have been recently changed. I did mess up when trying to start it the first time today. I pumped the bulb about three different times before realizing the kill switch was not in. Could this have fouled the plugs? I would really like to get ths thing on the water tomorrow. I know it will be a miracle but I dont have any more time... Sorry about the alcohol induced thread but I need some quick advice. I have searched beneath the cowling and have not found or smelled any excessive fuel leaks nor did I seee any burnt or disconnected wires. Help me please Chuck GIG'EM AGGIES | |||||||||
| Picklefork
Moderator Username: Picklefork Post Number: 703 Registered: 12-2009  Rating: N/A |
Be at service marine at 8:00 a.m. first thing....tell um pickle sent ya and if they don't take care of ya I'm gwana send a laws rocket straight up Perry's arse......AAAAhahahahahaaaaaaa...No shite Chuck..Be there at 8:00...Hopefully they can help..They are on 515 on the right just as you come in to Emory...903-473-3909 | |||||||||
| Chuck_a
Crappie Username: Chuck_a Post Number: 330 Registered: 2-2008 Rating: N/A |
Thanks Pickle. I am parked in front right now. Chuck GIG'EM AGGIES | |||||||||
| Tomc
Bass Username: Tomc Post Number: 963 Registered: 12-2006  Rating: N/A |
Yep, you are in a good spot. Thanking the Lord, all day long --- tomc | |||||||||
| Chuck_a
Crappie Username: Chuck_a Post Number: 331 Registered: 2-2008 Rating: N/A |
Dont think they are open today Chuck GIG'EM AGGIES | |||||||||
| Chuck_a
Crappie Username: Chuck_a Post Number: 332 Registered: 2-2008 Rating: N/A |
They are here now Chuck GIG'EM AGGIES | |||||||||
| Ozziefish
Lunker Username: Ozziefish Post Number: 2064 Registered: 8-2004  Rating: N/A |
OK whats the deal.... OzzieFish "Glory to GOD in the Highest" www.visionlure.com www.doublezzcustomlures.com www.procullfishing.com | |||||||||
| Chuck_a
Crappie Username: Chuck_a Post Number: 333 Registered: 2-2008 Rating: N/A |
I hope u are right about bad gas Oz but dont know yet Chuck GIG'EM AGGIES | |||||||||
| Picou
Wall Hanger Username: Picou Post Number: 4259 Registered: 8-2004  Rating: N/A |
If it is a carb motor I would say it is a plugged up jet. If its injected then I have no clue. Hope they get you back on the water ASAP.  Thank you Lord for my family and the waters I get to fish
| |||||||||
| Ozziefish
Lunker Username: Ozziefish Post Number: 2065 Registered: 8-2004 Rating: N/A |
any word yet??? OzzieFish "Glory to GOD in the Highest" www.visionlure.com www.doublezzcustomlures.com www.procullfishing.com | |||||||||
| Chuck_a
Crappie Username: Chuck_a Post Number: 334 Registered: 2-2008 Rating: N/A |
I have water coming out of the block in an area where I dont think there should be water. The gasket is blown out on some cover plate near the intake manifold. Putting it in the shop today. Doesn't look too good. Chuck GIG'EM AGGIES |
